Bowden Y-Splitter for Bambu Lab X1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows to use Bambu Lab's AMS with external filament.
- Ocena
- 4,768 / 5
- Polubienia
- 1710
- Pobrania
- 17 334
- Wydruki
- 160
- Wyświetlenia
- 65 744
- Oceny
- 125
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Print with ABS or PETG with brim and without support. Cut bowden properly at 90 degrees and insert fully (15mm, using a rag and some force; the bowden inputs are slightly conical). It will hold very well. If you have problems, you could reprint the splitter slightly smaller, say at 98% or so.
Make sure to disconnect or switch off the AMS before feeding the external filament. A filament runout sensor switch at the external bowden input cutting the power to the AMS can do this automatically (see separate model https://www.printables.com/de/model/262945-bambu-lab-automatic-ams-switch).
You must use “UNLOAD” when removing the external filament, not manual retract. This will give the filament a clean cut and it will not get stuck in the splitter.
Please see also: https://www.printables.com/de/model/300273-bowden-tube-y-splitter-with-pc4-m6-connections and https://www.printables.com/de/model/584189-clean-bowden-y-splitter