Calibration Block with Countersunk Hole and Slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Calibration Block with Countersunk Hole and Slot to catch problems with elements inside perimeter of object.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Attribution
Calibration Block with Countersunk Hole and Slot to catch problems with elements inside perimeter of object.
Instructions
I took the 20mm block from Spacexula's calibration set and added a countersunk screw hole for a M3 socket-head screw, and a slot for a M3 nut to be able to check my bots ability to accuratly do inside holes and slots in an object.
Edit: (from algspd's comments below, I updated the object to use values that should produce a snug fit, the old values were the nominal diameters for an M3 socket-head screw)
The head diameter is 5.89mm and the shaft diameter is 3.06mm, this should produce a snug fit. I created this calibration block to test the accuracy of the inside diameter of a hole on a Printrbot Plus, from a SketchUp file.
Category: 3D Printing Tests