1 / 7
Plug and play belted Nema 17 Gear Box for Extruders — zdjęcie 1
1 / 7

Plug and play belted Nema 17 Gear Box for Extruders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a plug and play belted gear box with 3.5:1 gear ratio (when using a 16t pulley). I'm using it on my Bear…

Ocena
0 / 5
Polubienia
5
Pobrania
15
Wydruki
1
Wyświetlenia
499
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a plug and play belted gear box with 3.5:1 gear ratio (when using a 16t pulley). I'm using it on my Bear extruder with an LDO 0.9 Slim Power stepper. Very inspired by https://www.thingiverse.com/thing:3553286 and https://www.thingiverse.com/thing:2845416

Print with PETG without supports, vertically (it should look like an arrow pointing up on the plate). Use at least 3 perimeters and 12% gyroid infill.

Required hardware:

3x m3 20-25mm screws + washers

1x gt2 140mm closed belt

1x 16t pulley

2x 105zz bearings

1x ~40mm x 5mm shaft

Category: 3D Printer Extruders

Tagi