IKEA Sinnerling Lamp shade replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement shade in two parts for IKEA's Sinnerling lamp. The lamps have a cork base with a large, fairly…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 711
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
This is a replacement shade in two parts for IKEA's Sinnerling lamp. The lamps have a cork base with a large, fairly heavy, frosted glass shade that sits over the cork base.
I bought 2 Sinnerling lamps from Ikea and had them delivered to my house. Unfortunately, I had a lot of problems receiving the lamps unbroken. I tried ordering the lamps several times, but was only successful in receiving one unbroken lamp. IKEA was very good about getting me refunds and re-ordering the lamps. On the final delivery attempt, I received one good lamp and one broken lamp. Since the base and electrical wiring of the lamp was fine, I carefully brushed off the broken glass, kept it and designed this Thing as a replacement shade. The last picture is of an undamaged, original IKEA Sinnerling lamp showing its glass shade.
My 3D printer's build volume is 250mm x 210mm x 210mm and couldn't accommodate a copy of IKEA's design, so I adjusted.
There are two parts to the lamp shade:
- A lower shade which sits on the lamp's cork base.
- An upper shade which sits on top of the lamp shade base piece.
The upper and lower shade pieces connect via 3 contact pads with small registration holes and pins in them. The lower shade has a smooth internal wall, while the upper shade has a thick hatch pattern.
I printed my lower shade in dark/opaque PLA while the upper shade was printed in natural/clear PLA.
NOTES:
- You'll need a fairly large print volume to print the shade parts. I used nearly the full volume of my Prusa MK3, which luckily was just large enough.
- The lower shade takes around 12 hours to print at 0.2mm layer height and 20% infill.
- The upper shade takes between 24-48 hours to print. I found that 0.2mm layer height with 5% infill gave me good results. I also noticed that changing the infill pattern had a great effect on print time.
- You'll notice that the upper shade on my lamp is in two parts. That's because I had a print pan failure right in the middle of the print and decided to split the print in two, which I glued together later, rather than waste a bunch of PLA.
Category: Decor