Thumbscrew Cap For M8 Socket Head Capscrew
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created this cap to use a M8 socket head capscrew as a thumbscrew with the V-block and clamp by i606.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 66
- Wydruki
- 1
- Wyświetlenia
- 326
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I created this cap to use a M8 socket head capscrew as a thumbscrew with the V-block and clamp by i606. I have plenty of M8 SHCS laying around so this seemed like a good way to put a couple of them to use.
https://www.printables.com/model/64972-v-block-with-clamp
It is a press fit so no glue needed. This lets you easily revert back to original configuration and at the same time it is a snug enough fit that it will not come off during use.
I printed solid as the walls are thin and it is a tiny part that takes less than 30 minutes to print.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
.20
Infill:
40%
Notes:
Infill doesn't matter for me as I set perimeters high enough to make this a near solid print.
I normally print in groups of four which takes just under 2 hours to print.
Category: Parts