1 / 3
SD || MicroSD card case
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
remix of a model for a case for (micro)SD cards with smaller form factor and slightly different tolerances for the slots
- Ocena
- 4,764 / 5
- Polubienia
- 439
- Pobrania
- 3153
- Wydruki
- 72
- Wyświetlenia
- 8628
- Oceny
- 55
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 72) (Komentarze: 84)Remiksy (4)Kolekcje (626)Powiązane
| BASIC DESCRIPTION |
- it is a remix of a model found here:
https://www.printables.com/model/20415-sdmicrosd-card-case
https://www.printables.com/model/23326-sdmicrosd-card-case-snap-fit
- this remix has 8 slots for microSD, and one for the adapter (or a full sized SD card)
| DESIGN DECISIONS |
- it was also completely remodeled from ground up because I have found that the two previous models had much tighter tolerances on the micro SD cards than I wanted it to have, so I made mine a little wider and with an additional cut out so the microSD cards can be slid out easier
- I really liked the snap fit on the remix so I incorporated it in my remix too
- also, I wanted to make it smaller and to pack as much as microSD cards as possible in this form factor, and only one adapter - I always only need one when I am on the road
| PRINT SETTINGS |
- General notions:
- no supports required
- The settings that I used:
- Resolution: 0.15 mm
- Infill: 20%
- Filament: PETG