Netatmo Outdoor Module Support and Sun Shield
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Netatmo Outdoor Module Support and two sun shield / weather protection variants to stick to window chassis or glass
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 816
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
The first goal of this multipart model is to provide a support for outdoor Netatmo module, to be stick to window or any flat surface. I personally use 3M VHB transparent double sided tape for that purpose.
There is two sun shield /weather protection included but I only use the simple one. It depends of module sunlights and/or weather exposition. Both can freely rotate to adjust angle.
In the picture* you'll see my own is quite well protected by the wall and only exposed to direct sunlight a few minute in the summer at sunset. The sun shield on the picture is covering a 120° angle.
F360 project available upon request for remix. Shroud Redux angle is parametric as well as gaps for the full enclosure.
All parts printed without support in Prusament PETG Signal White, default PrusaSlicer DRAFT 0.30 profile, no skirt, brim or anything like that.
Printed with Prusa MK3S in enclosure.
*Spiderweb not included :-p