Phone tripod with squeeze mechanism
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of SubSite's fantastic Phone Tripod. This remix uses a squeezing mechanism.
- Ocena
- 4,8 / 5
- Polubienia
- 79
- Pobrania
- 260
- Wydruki
- 6
- Wyświetlenia
- 1895
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution
This is a remix of SubSite's fantastic Phone Tripod. I wasn't a big fan of the screw tightening mechanism of the original, so I decided to remix it with a squeezing mechanism instead. This allows you to very quickly reposition the phone by simply squeezing the notches at the ball joint.
I've uploaded all parts for convenience although it is only the ball-joint part that has been remixed. The clamps and legs are untouched from SubSite's original designs.
Thank you to SubSite for making this tripod available for remixing.
Printing instructions
- As per SubSite's original instructions you should measure the width of your phone and print the matching clamp.
- When printing the base I highly recommend slicing from the provided tripod_base.3mf file. The model requires almost no support, but a tiny bit is necessary for the “squeezers” to print perfectly. This file has the required supports added.
- IMPORTANT! Print base part and clamp in PETG! The legs can / should be PLA.
- Recommend 0.2 layer height.
- All parts should have 3 perimeters for optimal shell stability / bendability (especially the clamp).
Last note: It wasn't until I was done designing and printing this remixed version that I noticed SubSite actually made a V2 of this tripod. Feel free to check that out too.