NoClogClone Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is a handle you can use if you want to create your own NoClogger device https://noclogger.com/.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 223
- Wydruki
- 6
- Wyświetlenia
- 1722
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a handle you can use if you want to create your own NoClogger device https://noclogger.com
This handle is designed to take a 1.6mm rod (the NoClogger version uses a 1.5mm rod).
You will need a 1.5mm to 1.6mm diameter rod, with the length depending on the length from the tip of your hotend to your filament insertion point. There is 1.5mm x 30mm deep hole in the design to make the insertion of the rod easier, but i heated my rod before inserting it to make it easier.
i printed this in ASA, with a brim but i don't think its needed.
Print orientation is as pictured.
just in case you are having a hard time sourcing your rod here's a link:
https://www.amazon.com/dp/B07KY8XJQL/?coliid=I132ULDJQS4F6A&colid=33BI8H756UJ6K&psc=1&ref_=lv_ov_lig_dp_it