Airtag Holder For Bike Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an airtag holder designed for a rear bike rack. Specifically designed for the Trek Bontrager Deluxe MIK.
- Ocena
- 5 / 5
- Polubienia
- 84
- Pobrania
- 165
- Wydruki
- 1
- Wyświetlenia
- 2067
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Overview
Hello everyone!
This is a Airtag holder I designed for my rear bike rack. I specifically have the Bontrager Deluxe MIK (this is the one in stock at my local Trek store) but this should work for anything where the poles are about .45" (11.43mm) in diameter and about 3.3" (83.82mm) apart.
Materials
- 6x M3x12mm button head screws
- 6x M3 nuts
- This screw assortment¹ contains everything you need
Print Recommendations
Since this part may be exposed to heat from the sun and water, I would recommend staying away from PLA, regardless of what you use this is a pretty easy print:
- Layer Height: 0.15-0.2mm Quality
- Infill: 10%
- Material: ASA recommended¹ due to UV, heat, and moisture resistance
- Supports: None
Diagram of Spacing
Model Files
Note: I make all of my models in Creo, Printables does not support the file type so I put all of my models in this GitHub Repo.
1) This post contains affiliate links, any link marked with ¹ is an affiliate link. Using these links helps support my work!