Fillament spool holder Direct Drive Ender 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hi there - i was looking for a robust and good spool holder to mount on top of my Ender 3 v2 I recommend my filament…
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 144
- Wydruki
- 1
- Wyświetlenia
- 2399
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Hi there - i was looking for a robust and good spool holder to mount on top of my Ender 3 v2
I recommend my filament guide here https://www.thingiverse.com/thing:4712122 to fit in front of the spool holder.
There was some but was really not impressed - i needed something else so i descided to design my own.
Some of the prats you need to print multiple of (2 of each)
EndCap
EndCap Support
Spacer
You need to do a pause on layer to put in a Nut/Lock nut in the EndCap, and its important to print the EndCap Support before the EndCap, because when you pause you have to put in the EndCap support plate after the nut - i usually put a small tip of super glue to keep it in place.
You need support on the base but use a support blocker on the roof so you dont get support all the way through.
You will need the following parts
1 threaded 6mm of ish 150mm
2 M6 Nuts / Lock nuts
2 608zz bearings
Super glue
4 T-nuts M4
4 M4 screws with alen head
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
40%
Filament: Spectrum PLA Gray
Category: 3D Printer Accessories