Osprey Hydration Magnet Clasp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement magnet clasp for Osprey hydration pack, fits Osprey clasp and base if only missing one half.
- Ocena
- 5 / 5
- Polubienia
- 35
- Pobrania
- 102
- Wydruki
- 1
- Wyświetlenia
- 893
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
Replacement clasp and base designed for Osprey hydration packs. Pieces can be printed together as a set or individually to replace a missing piece. These parts might work with other hydration pack systems I just don't have any to compare against, if you test it out and have success let me know.
Base fits 20mm (~¾") webbing, has a slightly recessed section with a diameter of 16.4mm (fitting existing Osprey clasps), and the clasp's bottom face is 16mm (fitting existing Osprey bases). The clasp has a 10mm diameter opening slightly flattened on one side to fit 10mm OD tubing tightly (in the US this is sold as ¼"), mouthpiece will need to be removed to feed tubing through clasp.
Base and clasp can both be printed flat on the bed. The clasps 10mm opening may sag slightly, functionality isn't effected but use supports if this bothers you.
Both clasp and base use embedded round 8x3mm magnets. If printing both halves make sure to orient your magnets correctly so they attract. If printing one half make sure to orient your magnet correctly based on your existing piece.
If you need details on pausing prints to embed magnets see the Prusa article here.