Piper Forward Air Vent Retainer (PA-28)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an air vent retainer for a Piper Archer PA-28-181 modeled from the front passenger vent. It should be…
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 464
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
If you want one of these but do not have a 3D printer contact the good folks at Ripperden Resources
This is an air vent retainer for a Piper Archer PA-28-181 modeled from the front passenger vent. It should be compatible with most Piper Cherokee Warriors.
See Also Air Vent: https://www.thingiverse.com/thing:4077743
V1 - Initial Drawing untested yet. After testing the inner round cutout is not correct. That needs to have an interior radius to accept the vent so stand by for V2.
V2 - Add relief to the inner ring to better accept air vent
V3 - Fixed inner ring curve. Compared to the original part and overall size holes all line up pretty good. The original part insets in the back so the printed part feels much thicker and ridged. Not sure if that is better or not. May do a V4 that thins out the part.
v4 - Changes part to be a 1.5mm shell which is much closer to the original part (not tested yet)
Similar to: https://www.knots2u.net/flange-piper-65735-05-65735-06-65735-07-65735-13-65735-19/
Category: Replacement Parts