Sliding Deckbox
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Deckbox for TCG playing Cards like MTG, Pokemon, Arcanite, etc.. The design is symmetric so halves can be swapped.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 581
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a deckbox for trading cards. The design has an open front so the two halves can be used as library/graveyard stack.
The lid and bottom are identcal parts. This makes it easy to print in multiple colors that can be recombined at will.
Printing:
I printed it in PLA with 0.25mm layer height without any support.
- Just print the Halfbox upright twice in colors of your choice.
- small support for the snap-in-clips is already included in the model and can easily be broken free or carefully(!!!!) cut with a knife.
Note: For sleeved cards there is another model. due to the symmetry it's not compatible with the unsleeved one.
Assembly:
After printing, just break the snap-in-clip support by pushing them inwards. Afterwards the two halfs can be slid into each other.
Note: breaking the support on the snap-in-clips might not be necessary or happen on its own while closing. Still i would recommend to do so beforehand, because it can be really tough to open otherwise.
Pre-Print-Decoration:
Thanks to Prusaslicer it's actually easy to use Negative volumes or modifier volumes (e.g. for fuzz) to use some stencil-like models for decoration of the box, drawer and lid. Just get creative with your own designs.