Sliding Deckbox
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Deckbox for TCG playing Cards like MTG, Pokemon, Arcanite, etc.. The design is symmetric so halves can be swapped.
- Rating
- 0 / 5
- Likes
- 12
- Downloads
- 39
- Makes
- 0
- Views
- 581
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Board Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a deckbox for trading cards. The design has an open front so the two halves can be used as library/graveyard stack.
The lid and bottom are identcal parts. This makes it easy to print in multiple colors that can be recombined at will.
Printing:
I printed it in PLA with 0.25mm layer height without any support.
- Just print the Halfbox upright twice in colors of your choice.
- small support for the snap-in-clips is already included in the model and can easily be broken free or carefully(!!!!) cut with a knife.
Note: For sleeved cards there is another model. due to the symmetry it's not compatible with the unsleeved one.
Assembly:
After printing, just break the snap-in-clip support by pushing them inwards. Afterwards the two halfs can be slid into each other.
Note: breaking the support on the snap-in-clips might not be necessary or happen on its own while closing. Still i would recommend to do so beforehand, because it can be really tough to open otherwise.
Pre-Print-Decoration:
Thanks to Prusaslicer it's actually easy to use Negative volumes or modifier volumes (e.g. for fuzz) to use some stencil-like models for decoration of the box, drawer and lid. Just get creative with your own designs.