Shutter Lid Box "Piccolo"

This is the smallest member of a series of Shutter Lid Boxes. Really cute and fits in every pocket. For small items like pills, screws, coins, paperclips, etc. The lid stays firm in opened or closed position independent in which direction the box is being held; still it can be opened with one hand. Actually once runned-in, it's really fun to play around with, kind of like a fidget toy. 

Check out other models at:

Pen Case: https://www.printables.com/de/model/261162-pen-case-small-item-case-with-shutter-lid

Tool Boxes, Index Cards, etc.: https://www.printables.com/de/model/143995-shutter-box-in-two-sizes

Print instructions and assembly:

• Print all parts in PLA (some people struggled to get the lid in when the main body was printed as a whole. So you might want to cut it in two pieces and then glue together).
  recommended settings:
  Box main body: Cut off one side at 3.5 mm, and print @ 0.2mm layer height. Main body needs to lay on the side for printing like in the picture
  Sides: print at @ 0.1mm
  Shutter: Good settings crucial for the shutter so that it will turn out flexible but sturdy enough. Layer height 0.05mm,  Top-/Bottom fill pattern: Archimedean Chords, Fill pattern: Line
• Once everything is printed, use glue to assemble the box (I used super glue). 
• First glue the separate side of the box into the side-part and then glue the two to the rest of the box. Make sure every thing lines up well and that there is no glue in the rails. 
• I used rubber bands to hold it together while the glue was drying.
• Once the glue on the box is properly dried, you may add a little grease / silicone spray to the rails. It will make the shutter run smoother.
• Carefully put the shutter in place.

Please let me know if you have problems or suggestions to make it better.