1 / 4
Infant Optics Baby Monitor Camera Adjustable Stand
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adjustable stand for an Infant Optics DXR-8 baby monitor camera
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 124
- Wydruki
- 2
- Wyświetlenia
- 989
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 2) (Komentarze: 3)Remiksy (0)Kolekcje (36)Powiązane
This is an adjustable stand for an Infant Optics DXR-8 Camera. The camera usually cannot angle down low enough and so this stand allows it to be adjusted to get a better view of the crib. It's ideal for travelling as it allows the camera to sit on any flat surface and has a hollowed out section in the base for more weight to be added. I used steel ball bearings to add weight but anything heavy can be used. I printed with 15% infill with Hatchbox PLA and it works great.
Hardware
- 40mm M3 bolt and M3 hex nut for connecting the hinge piece
- 12mm M4 bolt and M4 hex nut for the camera attachment mount
- 2x 1 1/16 inch (27mm) steel ball bearings or BBs for adding weighting to the base so it doesn't tip over