1 / 4
Flush Mounted LED Blinker Housing for Honda Navi
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple flush mounted housing for the S23 LED blinkers.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 1336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (13)Powiązane
This is a blinker/signal assembly for the S23 LED blinkers from ScooterSwapShop, found here for $10.
To complete this build as pictured, you will need:
- (2) M3x4 screws
- (2) M3x6 screws
- PRINT (1) of each file attached.
Printing
Everything was printed on my Ender3 Pro at .2mm layer height, and a standard .4mm nozzle. I use Gyroid infil at ~20%, but you can probably go lower. The main housing does require supports, but that is it.
Construction
- With all of the pieces printed, start by inserting the M3x4 into the inner bracket arm, and screwing it into the main housing.
- Next, take the M3x6 screw and screw it a few turns into the pilot hole to create the threads inside of the PLA.
- Unscrew the M3x6 screw and insert it into the inner brace for later.
- Now insert the LED through the front, and run the nut along the wire from the back.
- Screw the nut on a few turns, and then pull the LED outward to seat the nut inside the housing.
- Screw the LED in completely from the outside/inside until it is seated snuggly.
- Next, run the wire into the signal opening on your Navi. The bracket arm should ‘lock in’ pretty snuggly.
- Now with the M3x6 screw in the brace, screw it into the pilot hole from inside the headlight housing. (older version brace shown below)
- Now repeat the process on the other side.
Any and all comments/suggestions welcomed to further improve/change the design.