1 / 1
DIN Rail Mount for Shelly 2.5 and RGBW2
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are DIN Rail Mounts for a Shelly 2.5 and an RGBW2, which I used to mount the Shellies in my Voron 2.4
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 301
- Wydruki
- 0
- Wyświetlenia
- 1787
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (41)Powiązane
These parts mount the Shellies vertically on a DIN rail to save space in width on the rail. The shellies are meant to be slid in from the front and snap into place once fully inserted.
The snaplock onto the DIN rail is purposely quite tight. I lifted the latch over the rails edge with a flathead screwdriver.
I printed them in ABS with a 0.4mm nozzle with 4 perimeters and 40% infill, which are the recommended settings for structural Voron parts.