Nitecore TIP flashlight shell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement shell for the Nitecore TIP (V1). 1mm thick, 0.5mm detail, should work on both MSLA and FDM.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 407
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A replacement shell for the Nitecore TIP (V1). 1mm thick, 0.5mm detail, should work on both MSLA and FDM.
No supports needed.
In order to get maximum transparency using MSLA I used a clear resin (Anycubic Clear), printed the object flat on the build plate, cured in water (after washing) and gave it a few coats of clear spraypaint.
The Anycubic clear resin is pretty brittle, so take care not to over-tighten the screws. Siraya Tech Blu would probably be best if you want something tough and transparent, but as I don't have any, I had to make do.