Battery Box -9V - Gridfinity - Vasemode

This is a remix of Jboe's (https://www.printables.com/social/175315-jboe/about) vasemode battery holders. I only created the one I need because 1) I don't fully understand parametric modeling in Fusion and 2) if it were parametric, it would only hold 2 batteries per block. The way I designed it allows you to fit about 2.5 batteries per block. I didn't retain the countersunk screw holes but I have included the .3MF and the .F3D.

Print in vase mode the largest layer height your volumetric flow will allow, I used a 0.6 CHT nozzle with a .4 layer. Increase number of bottom layers to cover the baseplate - Jboe recommends 5.4mm and that works well.