Sorbothane feet for Official Prusa enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
1" and 1.25" sorobothane feet holders for the Prusa enclosure
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 66
- Wydruki
- 3
- Wyświetlenia
- 566
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v2.0
This is a remix of the enclosure feet created by Prusa to allow use for either the 1 inch or 1.25 inch sorbothane hemisphere feet. I found the rubber feet underwhelming.
I use sorbothane for the printer itself and it has almost completely removed the noise while the prusa printer is running.
For the 1" version, use the 70 durometer sorbothane, which can be found here:
https://www.amazon.com/Sorbothane-Hemisphere-Rubber-Non-skid-Adhesive/dp/B005JRMYG2
For the 1.25" version, use the 50 durometer sorbothane, here:
https://www.amazon.com/Sorbothane-Hemisphere-Rubber-Non-Skid-Adhesive/dp/B003IMJ3S2/
The 70 durometer 1" sorbothane will be right at capacity for the case + printer, but the 1.25" 50 durometer should be in the middle of the range and should allow for room to grow.
Note: These feet aren't meant to stack multiple enclosures on top of each other.