1 / 5
Digital clock with mechanical 7-segment display units
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Digital clock with mechanical 7-segment display units This clock uses four mechanical 7-segment display units.
- Ocena
- 0 / 5
- Polubienia
- 53
- Pobrania
- 88
- Wydruki
- 1
- Wyświetlenia
- 3058
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (75)Powiązane
Digital clock with mechanical 7-segment display units
- This clock uses four mechanical 7-segment display units, at https://www.thingiverse.com/thing:5066794
- Here I provide the base to arrange four units, rear cover and clock codes
Video
How to make
You need
- Four mechanical 7-segment display units, already published at https://www.thingiverse.com/thing:5066794
- 2mm tapping screws
- micro:bit
- Ks0360 Keyestudio Sensor Shield V2, https://wiki.keyestudio.com/Ks0360_Keyestudio_Sensor_Shield_V2_for_BBC_micro:bit
(other micro controllers can be used if it can handle 4 servos)
How to make
- Assemble 4 display units. Follow the instructions at https://www.thingiverse.com/thing:5066794
- Attach display units to the base, using 2mm tapping screws
- Fix the top of the neighboring display units using retainer.stl and screws
- Attach Ks0360 board to the bottom of the base
- Insert micro:bit to Ks0360 board
- Set rear covers (print two instances)



Adjustments of the position of the servos
### offset adjustment
- visit the site at https://makecode.microbit.org/ and upload check-offset2.hex
- fill the "offmap" table with zeros
- download the editted .hex file from the micro:bit site and flash it to the micro:bit board
- Find the best offset values. A/B button increases / decreases the offset value. Press A and B buttons simultaneously to increase the number to be shown (0-9).
- Write down the found offset values to the source code and check again.
using clock code
- upload clock.hex to micro:bit site
- Copy the offmap table from check-offset2.hex to clock.hex
- download the .hex file and flash it to the micro:bit
Category: Gadgets