Qidi X-Max Waveshare Display Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you want to switch your Qidi X-Max from the (slightly frustrating) original firmware to Klipper, then the original…
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 118
- Wydruki
- 1
- Wyświetlenia
- 2162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
If you want to switch your Qidi X-Max (1) from the (slightly frustrating) original firmware to Klipper, then the original touchscreen cannot be used anymore. But it is possible to use other touchscreens on your the RaspberryPI (which runs Klipper(screen)). Waveshare has a 5 inch touchscreen with a board which is smaller in width and height. It is therefore ideal to be used together with a self-designed adapter.
Additional materials required:
- 1m or 1.5m (depending on the position of your RPi) DSI/CSI 15 pin flat flex cable (please ping me if you find one with good EMI shielding)
- 8x short M2.5 screws to attach the display to the adapter (should hopefully be delivered with the display)
- use original screws to attach the adapter to the Qidi X-Max chamber
My display (or the Qidi display mounting points) was tilded for me by 0.23 degree. I've compensated this by misaligning the outer holes by 0.25mm. If you want to change this, please open the FCStd and change the Sketch "sk main" for "Pad main".
Please use only heat resistent material - normal PLA will just deform after the chamber warmed up when printing with 120 degree celsius on the heated printbed.
This design is not for X-Max 3 or later
Print Settings
Printer:
Qidi X-Max
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
25% Gyroid
Filament:
Polymaker PC-FR
black
Notes:
5 perimeters to make it stiffer
Category: 3D Printer Accessories