E3D V6 bolt on mount for Solidoodle 4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The solidoodle 4 has a different mounting setup to the solidoodle 2 and 3. This is based off zlagger design that can…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 186
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
The solidoodle 4 has a different mounting setup to the solidoodle 2 and 3. This is based off zlagger design that can be found on http://www.solidoodles.com/models/view/470
I cut off a few extra bits to make space for the side fan and that.
Ideally print in abs at 100% infill. The original bolts that held the SD4 extruder mount will be about 5mm too short so you'll need longer ones m3 x 30mm i think is what you need.
You'll also need to cut the spring down a little bit, one or two loops off should be enough.
Other than that you can use all the original parts
Category: 3D Printer Parts