E3D V6 bolt on mount for Solidoodle 4
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The solidoodle 4 has a different mounting setup to the solidoodle 2 and 3. This is based off zlagger design that can…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 186
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The solidoodle 4 has a different mounting setup to the solidoodle 2 and 3. This is based off zlagger design that can be found on http://www.solidoodles.com/models/view/470
I cut off a few extra bits to make space for the side fan and that.
Ideally print in abs at 100% infill. The original bolts that held the SD4 extruder mount will be about 5mm too short so you'll need longer ones m3 x 30mm i think is what you need.
You'll also need to cut the spring down a little bit, one or two loops off should be enough.
Other than that you can use all the original parts
Category: 3D Printer Parts