Tronxy X5S printed top frame extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A while ago I wanted to mount my 6 extruders bit differently on the frame, to maybe reduce the bowden tube lengths.…
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 70
- Wydruki
- 1
- Wyświetlenia
- 818
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A while ago I wanted to mount my 6 extruders bit differently on the frame, to maybe reduce the bowden tube lengths. For this I designed an extension to the frame using the extensible parts from Dollo3D printer. The printed parts are more than adequate for this task and allow for customization of the extra frame size.
About Dollo: https://github.com/spegelius/Dollo
Mounting stuff to the Dollo extension beams is up to you. There are some example extruder mounts here: https://github.com/spegelius/Dollo/blob/master/NEW_long_ties/adapters.scad.
Parts are mounted with bow ties: https://github.com/spegelius/Dollo/blob/master/NEW_long_ties/STL/long_bow_tie_split.stl
BOM:
- 4x Top_frame_frame_mount.stl
- 2x Top_frame_extention_t_part_front.stl
- 2x Top_frame_extention_t_part_back.stl
- 2x Top_frame_middle_extention_230.stl OR 4x Top_frame_middle_extention_115.stl
BOM (from https://github.com/spegelius/Dollo/tree/master/NEW_long_ties/STL)
- 4x corner_90_70_extra_stiff.stl
- very many bow_tie_with_brim.stl
- not quite as many long_tie_split.stl
- some long_bow_tie_split.stl, depends of what you are mounting to the frame
Optional:
- 4x extention_x.stl (for extra height, see the Dollo github)
The extention parts have a ~9mm hole through; use 8mm threaded rods and M8 nuts (nylock on other end) to get extra rigidity.
The OpenSCAD source for the frame can be found here: https://github.com/spegelius/3DModels/blob/master/PrinterParts/Tronxy/Top_frame.scad
Print Settings
Printer:
Tronxy X5S-2E
Rafts:
No
Supports:
No
Resolution:
0.15-0.25
Infill:
25%
Filament:
Any PLA
Black
Notes:
All the parts can be printed without supports, as custom supports are included. Printing the extention parts and matching bow ties might take some adjusting:
* first print an extention part * then print a couple of bow ties and long\_bow\_ties * see how they fit the holes on extention. They should be quite hard to insert, but still able to remove if needed. I prefer hard enough that you can't do it by hand, you'll need to use a screwdriver or something to tap them in. * adjust the tie dimensions in slicer if neededCategory: 3D Printer Parts