Traxxas Summit "Dog Carrier"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Shifter "gear" for the 1/10 scale Traxxas Summit. it is designed to eliminate the huge amount of slope in…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 32
- Wydruki
- 1
- Wyświetlenia
- 372
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a Shifter "gear" for the 1/10 scale Traxxas Summit. it is designed to eliminate the huge amount of slope in the original drivetrain. It should be a direct fit, but depending on your 3d printer it might need some filing.
Here are my settings:
extrusion multiplier: 0.9
layer 0.25mm
infill 100%
speed 40mm/s
supports: yes
With these settings there were only a small amount of afterwork needed. 100% infill is recommended for maximum strenght since it is a drivetrain part.
With this thing in my gearbox the summit has a play on rollout about 5 cm total! with stock part it was more than a half meter(50cm).
Category: R/C Vehicles