Traxxas Summit "Dog Carrier"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Shifter "gear" for the 1/10 scale Traxxas Summit. it is designed to eliminate the huge amount of slope in…
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 32
- Makes
- 1
- Views
- 372
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Share Alike
This is a Shifter "gear" for the 1/10 scale Traxxas Summit. it is designed to eliminate the huge amount of slope in the original drivetrain. It should be a direct fit, but depending on your 3d printer it might need some filing.
Here are my settings:
extrusion multiplier: 0.9
layer 0.25mm
infill 100%
speed 40mm/s
supports: yes
With these settings there were only a small amount of afterwork needed. 100% infill is recommended for maximum strenght since it is a drivetrain part.
With this thing in my gearbox the summit has a play on rollout about 5 cm total! with stock part it was more than a half meter(50cm).
Category: R/C Vehicles