HC fanduct - turbo fan duct add-on for E3DV6 and BMG Bondtech
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
HoneyComb fanduct for TURBO Fan (40x40x20) like add-on for E3DV6 hotend (ideally combined with BMG BondTech direct…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 397
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
HoneyComb fanduct for Turbo Fan (40x40x20) like add-on for E3DV6 hotend (ideally combined with BMG BondTech direct drive extruder).
- I revised the model to a new version, Rev2_2024, the main changes are:
- More accurate dimensions
- It is lighter
- Slots for M3 nuts
- Groove for TurboFan cable
- Slightly modified design
- The Fanduct is mounted directly on the original V6 hotends Fan.
- This settup is efficient enough, normally when printing, the fan speed is sufficient at 55%... the bridges, overhang and short layers at 65%.
- Prints well, no big angles, no supports.
Print settings: 🖨⚙
- Material: PLA, PETG
- Layer height: 0.25
- Wall count width: 3 perimeters (nozzle 0.4), 2 perimeters (nozzle 0.6)
- Infill: 30%
- Support: NO
Assembly: Is needed: ⚠
For attachment all fanduct on E3DV6 hotend:
- 4x wood screw (3.0x20mm), 2mm longer than the original.
For Turbo Fan attach:
- 3x M3 L20mm Screws (for example: flat countersunk head, Phillips PH1).
- 3x M3 Nuts.
---------------------------------------------------
PLA temperature resistence: I've been using it for a long time, for example prints Bed 70°C, nozzle 230°C with no PLA deformations (It is cooled from the inside by a Part cooling fan).
Modeled in the program: SketchUp
Printer brand: DIY
---------------------------------------------------
The photos below show the older version, but the basic shape is the same: 📷






