Locomotive "Stirling One No1 (Eight Footer)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loved this when i saw the picture.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 479
- Wydruki
- 0
- Wyświetlenia
- 2338
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
Loved this when i saw the picture. It lives in the Railway Museum in York, but 5" scale models are to be found in Brighton, Exmouth and Worthing according to Wikipedia.
A tender will follow as and when. Tender now included. The mid sized wheels fit this. (The loco's rear wheels.)
I have used the same device as I did with the S160 so that the wheels will spin freely and adjust to corners. This involves a bushing made from 4mm plastic tubing, usually meant for drain pipes and the like, cut into 4mm lengths and split with a removal of a 0.5mm slice. I have included a screen shot showing the wheel/axle assembly using this solution. The reasons being, the resin does not freely glide against itself or the Peco wheels, a means of holding the axles in place was needed, and this system allows the wheels to drift a little in their housings which is necessary when a long line of wheels go round corners if they are not on bogies.
Print instructions
Designed to print with Elegoo mars SLA 3D printer.