Funnel for 54mm Breville Bambino Plus Portafilter - Fits Smartgrinder Pro Cradle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I could not find a dosing funnel for my Breville Bambino Plus 54mm Portafilter (PF) which fits into the PF holder of…
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 250
- Wydruki
- 6
- Wyświetlenia
- 1721
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
I could not find a dosing funnel for my Breville Bambino Plus 54mm Portafilter (PF) which fits into the PF holder of my Smart Grinder Pro. The ones I have tried are too tall so I had to tilt the PF forward a little just so it goes through the cradle slot to reach the on/off activation switch, and the bottom spout hits the grinder tray. So I made my own funnel from scratch in fusion 360, though inspired by other's design like DogsBollocks and DrawnToDigital.
I used clear PETG at 20% infill so the infill lines are visible as shown in the photos.
PETG is preferred over PLA for food safety.
0.4 nozzle
0.2 Layer height
Supports: Yes
Place bottom side up in the bed for cleaner prints.
Category: Kitchen & Dining