1 / 3
Bigtreetech EBB 36 LDO Orbiter 2.0 EVA 3.x mount with strain relief
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
It's a remix of @iainwlg's "EVA3 Orbiter1.5 EBB36 mount", just fitting for the Orbiter 2.0.
- Ocena
- 5 / 5
- Polubienia
- 77
- Pobrania
- 663
- Wydruki
- 1
- Wyświetlenia
- 5977
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 12)Remiksy (5)Kolekcje (112)Powiązane
Why?
I simply couldn't find an EBB 36 adapter for the LDO Orbiter 2.0 on EVA 3.x, but there was that ingenious mount from @ianwlg so I had to remix it.. ;-) My version makes use of the gained space of the Orbiter 2.0 by moving the main plate 10mm towards the Orbiter and adapting the screw holes to the changed geometrie of the extruder motor.
Features:
- 10mm more a.p. space for your chubby crimping fingers…
- 4 point stabilization (inferior 3 holes, 2 Orbiter mounts, and an additional small “post” on the low posterior side) makes the hole plate less wobbly, your ADXL will love you…
- Standard brass standoffs, that come with with the EBB36 will fit this version. I used nylon for personal preference (black over brass color), but this is up to your gusto.
Requirements:
- Unfortunately you have to use a small amount of support below the triple screw EVA mount. A
- As @iainwlg mentioned: it is recommended to use some heat resistant material (PC, PC-CF, ePA-HT), although my ASA version is still quite brave.
According to the mounting procedure, please check the photographs.
I hope you like it :-)
Update 2022 08 31: Added the .step file