RBX24 (Rock Bouncer SCX24 Model) V1

DEPRECIATED
Here is version 2:
https://www.printables.com/model/279013-rbx24-scx24-rock-bouncer

Here is version 1 of my RBX24, Rock Bouncer chassis for the scx24. It's based on the IRL Revolution 2.0 chassis. 

https://www.wideopendesign.com/revolution-2-0-rock-crawler-chassis

Print Settings:
I'd recommend printing the frame from 0.2mm to 0.1mm layer heights using 100% infill.

Tree/normal support is fine. Use “touching build plate”.

Assembly:
I recommend gluing all the panels to their respective parts first before assembling the chassis. (Any CA or super glue should work)

The chassis uses all 5mm screws except for the cooler which can take 8mm screws.

If the holes feel too tight, use a 1.5mm drill bit for holes that don't need threading and a 1.2mm drill bit for holes that need threading.

Chassis Specs:
So far I've only tested the build with the stock ESC and motor. Any motor similarly sized/ longer should also work. 

Only the stock battery or smaller can be used. A small wire extender is required for the battery to reach the ESC. I used a JST-style connector and glued it down to the battery tray.

While the switch is reachable with a screwdriver, id recommend leaving the switch in the ON position and just using the battery to power on and off the ESC. 

For my build, I plan to use c10 rears for the front links and deadbolt rears for the rear links. This gives plenty of room for steering servos. 

 

Any Questions or recommendations please leave a comment.

Please leave a like and post your make! I'd love to see what color combos and customizations yall come up with.