E3D v6 Hotend - 40mm Fan Duct Laminar Flow (Improved airflow)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design should improve extruder cooling by a few degrees, my goal was to make airflow better so I could decrease…
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 626
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This design should improve extruder cooling by a few degrees, my goal was to make airflow better so I could decrease the extruder fan RPM to make it quieter.
I don't have any accurate way of measuring airflow, so instead I inserted a thermocouple sensor inside the extruder tube and measured the temperature right before the heater block, which should be the hottest point in the neck of the heat-break. Then I set my nozzle temperature to 250ºC which is 15ºC above what I usually print. Then set a stopwatch to 10 minutes so it had time for the temps to settle. And I then I tried a few designs and compared the differences.
Print Settings
Printer:
Graber i3
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
25%
Filament:
Generic ABS
Black Custom Section ==============
Category: 3D Printer Parts