1 / 5
E3D v6 Hotend - 40mm Fan Duct Laminar Flow (Improved airflow) — image 1
1 / 5

E3D v6 Hotend - 40mm Fan Duct Laminar Flow (Improved airflow)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This design should improve extruder cooling by a few degrees, my goal was to make airflow better so I could decrease…

Rating
0 / 5
Likes
8
Downloads
64
Makes
0
Views
626
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

This design should improve extruder cooling by a few degrees, my goal was to make airflow better so I could decrease the extruder fan RPM to make it quieter.

I don't have any accurate way of measuring airflow, so instead I inserted a thermocouple sensor inside the extruder tube and measured the temperature right before the heater block, which should be the hottest point in the neck of the heat-break. Then I set my nozzle temperature to 250ºC which is 15ºC above what I usually print. Then set a stopwatch to 10 minutes so it had time for the temps to settle. And I then I tried a few designs and compared the differences.

Print Settings

Printer:

Graber i3

Rafts:

No

Supports:

No

Resolution:

0.15

Infill:

25%

Filament:

Generic ABS

Black Custom Section ==============

Custom Section

Category: 3D Printer Parts

Tags