Netgear GS308 Switch Stacked Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting two Netgear GS308 switches on top of each other onto a wall (or desk).
- Ocena
- 5 / 5
- Polubienia
- 25
- Pobrania
- 233
- Wydruki
- 2
- Wyświetlenia
- 1901
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed a way to mount two GS308E Netgear switches onto a wall on top of each other to conserve space so designed these wall mounts that fit around the switches. I have left room below the switches to pass cables, and left gaps between the switches and inside the mounts for ventilation that correspond with ventilation rosters on the switches themselves.
Only suitable for down/left/right orienation, and can also be mounted hanging. Do NOT mount the switches with the ports facing upward as this will most likely result in the switches falling out.
I have experienced the best printing result by printing them flat (screw holes facing down) onto the build plate and adding supports for the overhangs. 40% infill (gyroid) for strength. The images I've attached were printed in Fiberlogy Easy-PLA and that went quite well.