Odyssey 7Q / 7Q+ Support Legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Handy dandy legs to support your precious Convergent Design Odyssey 7Q or 7Q+.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 379
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print a pair of these bad boys, slap some 1in hard side on the feet, and mount one to each side of your 7Q using a ¼-20" thumb screw and 2 washers and you'll be in business.
Although I've since upgraded to a fancy-pants Leader for my scopes, when I was using my Odyssey's I'd run them inverted for easy access to the inputs and power jack - but you do you baby.
These are quick to print with PLA. A 0.2mm layer height is plenty, though I recommend a minimum of 3 perimeters just to keep things stiff near the pass-through holes for the thumbscrews.
I've included F3D and STEP files just in case you'd like to tinker.