Alternative Spool Holder for Drybox V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An alternative spool holder which fits into the centre of the spool. Designed to fit Odrej's Drybox design
- Ocena
- 5 / 5
- Polubienia
- 37
- Pobrania
- 208
- Wydruki
- 4
- Wyświetlenia
- 1525
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is an alternative spoolholder which fits inside Ondrej Stritesky's drybox design. I found the spool rollers along the bottom required metal rods which I didn't have, and it also created a lot of rolling resistance which was too much for TPU and other flexibles. So I deisnged this which slots into the same place and allows the spool to be held in the centre instead. This allows the spool to roll a lot more fluidly, and only requires 2x 608 bearings instead of 4.
All parts are designed to be printed in PLA with no supports at 0.2mm layer height. Step files are also shared here for remixing and editing
If you've liked this model, feel free to tip me a buck or 2
https://ko-fi.com/henryj