Pwnagotchi case for Waveshare and Pi Sugar v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The cases in the original only had versions for the Pi Sugar v1. The V2 has both a switch and a button. I rejigged the…
- Ocena
- 3,75 / 5
- Polubienia
- 33
- Pobrania
- 504
- Wydruki
- 3
- Wyświetlenia
- 2341
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
The cases in the original only had versions for the Pi Sugar v1. The V2 has both a switch and a button. I rejigged the case based on both this and the Pi Sugar cases (purely used to get the hole locations correct) and updated the buttons and the switch parts to make them easier to print.
This fits a standard Pwnagotchi build, with a Waveshare screen and the Pi Sugar V2 1200mAh battery.
I'm still working on improving the design for it a little, I'd like to move where the carabiner loop is slightly, and rejig where the holes for the battery status on the Pi Sugar are as they don't quite line up correctly, but for the moment, it works.
I may also make a version without the loop whilst I'm at it.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Notes:
I found that I didn't need supports and that the printer bridged the top edge of the space for the screen just fine. Your mileage may of course vary.
Category: Electronics