Panavise 308 Heavy Base Helping Hand Ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the "Helping Hands for Panavise" by sprior. Sprior's STL was over 300k triangles so, to open in…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a remix of the "Helping Hands for Panavise" by sprior. Sprior's STL was over 300k triangles so, to open in Tinkercad and remix, used Meshmixer to get down to Tinkercad's 300K limit. This version is intended to be used with the Panavise Model 308 heavy cast iron base.with it, the front of the vise is uncluttered and the helping hands, when installed are located from 9 to 3 o'clock. The tab at the front of my ring is and afterthought as a lifting point to slide vise and possibly as a point to mod, in a new STL, with a screw hole in the future for adding tool holder, solder guide, wire guide, parts tray etc. I'm open to suggestions and request if there is any interest.
Print Settings
Printer:
Ender 3 S1
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30%
Filament:
Overture PETG
Red
Category: 3D Printing