Nucleo 64 case with cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A case for nucleo-64 with mounting holes so you can mount it to wall. Cover included Need M3x8 screws and M3 nuts.
- Ocena
- 5 / 5
- Polubienia
- 22
- Pobrania
- 496
- Wydruki
- 3
- Wyświetlenia
- 2324
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I needed some kind of protection for my nucleo board so I won't kill it with ESD.
I tested it with the L452RE and L452RE-P (the variants with miniUSB and microUSB), but it should fit most if not all Nucleo-64 formats.
You need M3x8 screws and nuts to secure the nucleo board - and I strongly advice to only use two screws (left and bottom one) - the design of arduino layout is dumb and the right screw will collide with GPIO header. Also, 2 screws are enough to hold it nicely.
The case has two triangular slots in front and back, for the snap-fit cover - the GPIO headers stay accessible.
The cover incorporates two buttons.
Also 4 holes for mounting screws.
I printed with 0.3 layer, 3 perimeters, 4/3 top/bottom layers, 16% infill.