S1 Endpoint 40mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for RPI with extra internal space. Designed for 40mm fans. High impact at 50% infill, Stand on it at 70% infill.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 15
- Wydruki
- 1
- Wyświetlenia
- 270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — NoDerivatives
This RPI case is designed for high stress environments. Print it with 50% infill for most needs or 75% if you want to stand on it. It takes 40mm fans and has enough room for expansion board and additional side mounted hardware. It also sports a tie down strip incase you want to internally secure your side mount cables.
Everything is new user friendly with printing. The print difficulty is pretty much 0 as the only way you can mess it up is by having loose belts or a build sheet that isnt correctly heated.
Use thermal reflective tape below and above rpi, inside of case if its put in a low airflow location and you intend run it for long periods of time. This is not needed but it will help with keeping the print from sagging over time.
If you have any questions please post them here or reach out on twitter.
link in bio.