Furrion S7 Display Shroud
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Display shroud that mounts on the Furrion backup camera monitor to block the sun.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 474
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
The display for the Furrion S7 is not as bright as it should be for where it needs to be mounted to be used while driving. This shroud blocks the sun to help it to be viewed easier. Be sure to print with the shroud part pointing up to minimize print time, essentially put it on its back. I REALLY tried to design this without the need for supports but I couldn't do it. Print in PETG or some other sort of heat tolerant material. 0.20 is adequate, add a brim as there isn't a lot of surface area touching the build plate and could detach easily. Supports everywhere but allow for automatic detection (0 value) if using prusaslicer. Only the bottom part (the part that fits over the monitor itself) needs supports.