Furrion S7 Display Shroud
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Display shroud that mounts on the Furrion backup camera monitor to block the sun.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 99
- Makes
- 0
- Views
- 475
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution
The display for the Furrion S7 is not as bright as it should be for where it needs to be mounted to be used while driving. This shroud blocks the sun to help it to be viewed easier. Be sure to print with the shroud part pointing up to minimize print time, essentially put it on its back. I REALLY tried to design this without the need for supports but I couldn't do it. Print in PETG or some other sort of heat tolerant material. 0.20 is adequate, add a brim as there isn't a lot of surface area touching the build plate and could detach easily. Supports everywhere but allow for automatic detection (0 value) if using prusaslicer. Only the bottom part (the part that fits over the monitor itself) needs supports.