1 / 1
Prusa Face Shield - RC3 (More reliable printing and no laser cutter required)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Please read Prusa Research's original post "Prusa Protective Face Shield - RC3" for all best printing practices around…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 231
- Wydruki
- 0
- Wyświetlenia
- 1892
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Please read Prusa Research's original post "Prusa Protective Face Shield - RC3" for all best printing practices around sanitation before printing!
Prusa Protective Face Shield - RC3 (Remixed for more reliable printing on not perfectly calibrated printers and jigs for fabrication using hand drills and kitchen shears instead of a laser cutter)
- Outside geometry has been slightly changed to allow for faster printing speeds while keeping the correct radius of the face shield (~13% faster print times)
- For San Francisco Bay Area have sourced a local plastic supplier:
-https://www.tapplastics.com/about/locations/detail/san_francisco_ca
-24" x 48" x 0.02" clear polycarbonate sheet
-Modified design to use a 8" x 8" face shield for 0 waste fabrication
-Can cut 8" squares using kitchen shears or strong scissors
-Filet bottom two corners
-Designed drill jigs to create holes using a hand drill instead of needing a laser cutter
-Pilot hole with 5/64" bit, then drill actual hole with 1/4" bit for top and 3/16" bit for bottom - Option with holes or no holes (no holes uses slightly more material but will print slightly faster)
- Uses original "bottom_reinforcement" file (which I have also uploaded on this page)
- Printed with 0.4 mm nozzle, 0.25 mm layer height, 60 mm/s print speed, and 30% infill
- As Prusa recommends, use PETG filament if possible
*Still a work in progress, designs may change