1 / 1
Single Coil Guitar Pickup Covers
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Three guitar pickup covers for customizing the guitar look. Bottom fill patterns can create some cool custom effects.
- Ocena
- 5 / 5
- Polubienia
- 58
- Pobrania
- 587
- Wydruki
- 7
- Wyświetlenia
- 2747
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 7) (Komentarze: 16)Remiksy (0)Kolekcje (94)Powiązane
This was a project I created when rebuilding a Squire Strat/Starcaster mashup. You can judge that's fine; I used what parts I had to learn finishing, wiring and setup…free is the best when learning. :)
I've included hole templates so you can design your own. This was created for the 48, 50, and 52-mm spaced pickups.
Printing Instructions:
- Measure the height of your pickup, you may need to scale. Not all pickups are the same. These worked for the two sets I have based on a Fender single coil.
- Material - Any, PLA is pictured
- Layer height - does not matter, the default .20mm in Prusa Slicer was used for the one pictured (.15 may give the slight curve a nicer appearance)
- Orientation - Recommend pickup front facing down on a smooth sheet. You can print facing up, but if you want a glossy finish, you'll need to wet sand and use automotive rubbing compound to achieve it. It's less work to achieve it printing pickup face down on the smooth sheet.
- Bottom (or top) fill pattern - Whatever suits your fancy. You can achieve some cool effects based on the infill patterns. (Pictured is Octagram Spiral)