DS18B20 Temperature Sensor Probe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This mount can be used to mount against something and have the sensor probe poke through.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 148
- Wydruki
- 1
- Wyświetlenia
- 1328
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This mount was built for this project: https://github.com/BrobstonCreations/delta-tango
Specifically to mount a DS18B20 temperature probe to the outside of an HVAC duct, but poke the temperature probe into the duct.
In my case, this will also be used with Octoprint to create a heated chamber and switch a small heater on/off based on DS18B20 temperature probe temperature.
Hardware:
(2) Sheet Metal Screws
(1) M3x0.5 10mm Screw
The set screw hole is too small to 3D print threads, so you will either need to use a tap or the screw itself.