DS18B20 Temperature Sensor Probe Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This mount can be used to mount against something and have the sensor probe poke through.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 148
- Makes
- 1
- Views
- 1,328
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This mount was built for this project: https://github.com/BrobstonCreations/delta-tango
Specifically to mount a DS18B20 temperature probe to the outside of an HVAC duct, but poke the temperature probe into the duct.
In my case, this will also be used with Octoprint to create a heated chamber and switch a small heater on/off based on DS18B20 temperature probe temperature.
Hardware:
(2) Sheet Metal Screws
(1) M3x0.5 10mm Screw
The set screw hole is too small to 3D print threads, so you will either need to use a tap or the screw itself.