Mechanical carousel with horses

Attention Upgrade !! - improvement to the motor version

You only need to print two parts, buy the N20 Mini Metal Gear Motor and a box for two 18650 batteries. I will add a link to buy.
The motor is suitable with a speed of 30-50/min. I bought more motors for another model, but they helped me here

The height of the motor body with gears should be 25 mm without the shaft

N20 Mini Metal Gear Motor :

https://www.aliexpress.com/item/1005005699205905.html?

Battery 18650 box :

https://www.aliexpress.com/item/1005003772436297.html?

Just add these parts :

Put the new part under the carousel, insert the motor connected to the cables and add the gears

------------------------------------------------------------------------------------------------------------------------------------------------------------------------

As already mentioned in the competition entry, I created a mechanical model and tried to make the aesthetic side stand out as well. I hope you will like the carousel model. You can move the model in different ways - spin from the side by the gears or from above through the top. More experienced modelers can bring this model to life with motorized movement .
Horses move in 3 directions - back and forward,  around their axis  and up and down.

Update!! 

Added stl files of all parts of the model, I hope everything will be fine, if not write, I will fix it

Tvrdé: Použil som 9 kusov ložiska 608zz- / 8x22x7mm / ložisko vyrobené z inline lúča a 1 kus 6903zz / 17x30x7mm /

Use 6 pieces 608 bearings for a large rotating plate under horses, press them properly and use 3 pieces 608 bearings in the outer gears where the golden horses are. Bearing 6903- /17x30x7mm/ use it in the hole in the base - the big gray part, it helps turn the big golden circle.

I recommend smoothing out the waves on the base a little so that the horses move better.
The parts fit together just right, maybe you need to push the bearings into the moving plate a little.

The axles under the horses may need to be sanded a little so that they move freely in the holes in the toothed axles. If there is a problem, write to me, I will be happy to help

Added part: a turning stick, you can insert it instead of a horse

In case of problems when slicing 3mf files - if holes are missing in the parts, I recommend using the Prusaslicer

Filaments used: Prusament PLA Viva La Bronze
                             Prusament PLA Galaxy Silver

                                You can find another carousel model  here:

  https://www.printables.com/cs/model/275718-wheel-carousel-with-hearts

https://www.printables.com/cs/model/295206-carousel-with-butterflies-and-caterpillars

                                                  I wish you a lot of fun!